A breach of contract in which a major violation of the contract terms did not occur and usually does not result in termination of the contract is called a(n) ________ breach.

As an employer, you are required to report all new employees to the North Carolina New Hire Reporting Program no later than __________ from the date of hire or rehire.

The American with Disabilities Act prohibits discrimination against persons with disabilities and applies to employers with ___________ or more employees.

Which of the following OSHA forms is an individual incident report that provides added detail about each specific recordable injury or illness?

Which of the following conductor types is not allowed for use in a wet location?

The size of the grounded circuit conductor for a 400 amp feeder shall not be smaller than ______________.

When a piece of equipment is required by the N.E.C. to be in sight from another piece of equipment, the specified equipment must be visible and not more than ___________ away from the other.

The minimum bending radius for trade size 2 nonmetallic underground conduit with conductors is ____________.

The demand factor for a service supplying 20 mobile home lots is ___________.

Using the optional method of service load calculations, what is the calculated service load for 24 electric clothes dryers, with a nameplate rating of 4,100 watts, installed in an apartment complex?

Type LFNC-B is allowed to be installed as a listed manufactured prewired assembly in trade sizes ____________.

What is the approximate voltage dropped in a 1-phase circuit, that is 188 ft. in length when 8 AWG copper conductors are used to supply a load with a current draw of 36 amperes?

For electrical systems rated over 1,000 volts, the length of pull boxes, where straight pulls are made, shall not be less than __________ times the outside diameter, over sheath, of the largest nonshielded conductor or cable entering the box.

A dwelling unit is equipped with a single-phase, 240 volt, 200 ampere service. The home has electric heat and air-conditioning. The electric heater has a rating of 15 kW and the air-conditioning unit is rated 7,800 watts. What is the minimum load required to be added into the service calculation for the air-conditioning unit?

Which of the following statements regarding the grounded conductors at switch locations is/are true?
I. A grounded conductor is not required at the switch location where the lighting in the area is controlled by automatic means.
II. A grounded conductor is not required at the switch location where the switch controls a receptacle load.

Transformer secondary conductors rated over 1,000 volts and used for field installed neon tubing shall not exceed __________ in length where installed in metal conduit.

For other than totally enclosed switchgear, a space of not less than ________ shall be provided between the top of the switchgear and any combustible ceiling, unless a noncombustible shield is provided.

The purpose of the 2017 National Electrical Code is ______________.

Nonmetallic sheathed cable is not required to be secured to a single-gang, nonmetallic 2 ¼ in. x 4 in. outlet box if the cable is fastened within __________ of the box.

What minimum size THW copper feeder conductors are required to supply the following 3-phase, 460 volt motors?
1 – 10 hp
1 – 30 hp
1 – 50 hp

All electrified truck parking space supply equipment shall be accessible by an unobstructed entrance or passageway not less than _________ wide.

Indoor antennas shall not be nearer than _________ to conductors of other wiring systems.

Which of the following raceway types would not be allowed for the protection of a grounding electrode conductor smaller than 6 AWG?

Where smoke detectors are installed in concealed locations more than _________ above the finished floor or in arrangements where the detector’s alarm or supervisory indicator is not visible to responding personnel, the detectors shall be provided with remote alarm or supervisory indication in a location acceptable to the authority having jurisdiction.

The operable part of a manually actuated fire alarm initiating device shall be not more than ___________ from the finished floor.