The examination fee for all qualifying electrical examination in the state of North Carolina is __________.

An LLC must consist of at least _____ member(s).

A __________ bond guarantees that liens cannot be placed against the owner’s property by contractors for payment of services.

Which of the following should be included in the work orders of a status report?

What is the full-load current of a 1-phase, 115 volt, 2 hp motor?

A bank has an 800 amp service installed that is supplied with 2 sets of 500 kcmil copper ungrounded service entrance conductors connected in parallel. What minimum size copper grounding electrode conductor is required for the connection to the underground metal water piping system?

The area within ___________ horizontally from aircraft fuel tanks in an aircraft hangar shall be classified as a Class I, Division 2 location.

A connection shall be made between the one or more equipment grounding conductors and a metal box by means of a grounding screw _____________________, equipment listed for grounding, or a listed grounding device.

A receptacle shall not be grouped or ganged in enclosures with other receptacles unless they are arranged so that the voltage between adjacent devices does not exceed __________ unless suitable barriers are installed between adjacent devices.

Power-limited fire alarm cable shall have a voltage rating of not less than _________.

Where equipment is grounded and is supplied by separate connection to more than one circuit or grounded premises wiring system, an equipment grounding conductor termination shall be provided _____________.

The disconnecting means for a mobile home shall be installed so that the center of the grip of the operating handle, when in the highest position, is not more than __________ above the finished grade or working platform.

Network-powered broadband communications cables attached to buildings and located outdoors within __________ of finished grade shall be protected by enclosures, raceways, or other approved means.

A disconnecting means shall be provided and located in a readily accessible location for electric vehicle supply equipment rated more than __________ or more than __________ to ground.

A 125 ampere tap is being made from a 1,200 ampere rated feeder. What minimum size RHW copper conductors are required for this tap if the tap conductors are 18 ft. in length?

Low-voltage lighting systems shall be supplied from a branch circuit rated not more than ____________.

Which of the following statements is/are true regarding the use of a white insulated conductor as an ungrounded conductor in an electrical system with a voltage to ground of 120 volts?
I. It is allowed if used in a single pole switch loop when used as the supply to the switch and permanently reidentified at its termination.
II. It is allowed if used in a 3-way switch loop as a return conductor from the switch to the outlet and permanently reidentified at its termination.

A luminaire that weighs more than ________ shall not be supported by the screw shell of a lampholder.

What is the maximum rating allowed for the overcurrent protective device used for protection of an arc welder with a primary current rating of 63 amperes?

Type FC cable shall have the temperature rating durable marked on the surface of the cable at intervals not exceeding _______________.

All electrical equipment shall be installed so that any hinged panel or door shall open a minimum of _______________.

How many surge arresters are required for a 3-phase, 4 wire electrical system rated over 1,000 volts?

What is the minimum phase-to-phase clearance required for live parts operating at 7.2 kV if the equipment is field-fabricated and located indoors?

A discharge test is required to be performed for nickel-cadmium batteries used in fire alarm systems _____________.

Wall-mounted visible fire alarm notification appliances shall be mounted such that the entire lens is not less than __________ above the finished floor.