Material stored inside buildings under construction shall not be placed with ___________ of any hoistway or inside floor opening.

Testing of a lineman’s lanyard shall be conducted by attaching a canvas bag of sand to one end and attaching the other end to a rigid support and allowing the bag of sand to fee fall _____________.

What is the total resistance of a parallel circuit containing 1 – 20 ohm resistor, 1 – 400 ohm resistor, and 1 – 500 ohm resistor? (All resistors are connected in parallel.)

Electrical nonmetallic tubing shall be securely fastened at intervals not exceeding ____________.

Which of the following statements is/are true regarding photovoltaic system disconnecting means?
I. Each PV system disconnecting means shall be suitable for use as service equipment.
II. Each PV system disconnecting means shall consist of not more than 2 switches or circuit breakers.

Pipe or conduit used as a grounding electrode shall not be smaller than trade size ___________.

In which of the following occupancy types would a panelboard, rated not over 200 amps, be
permitted in a space where the height of the working space is 6 feet?

Isolated grounding type receptacle outlets shall be identified by a(n) ______________ on the face of
the receptacle.

Exposed, normally non-current carrying metal parts of fixed equipment supplied by or enclosing
conductors or components that are likely to become energized shall be connected to an equipment
grounding conductor where within ________ vertically of ground or grounded metal objects and subject
to contact by persons.

Which of the following statements is/are true regarding lighting track?
I. Heavy-duty lighting track is lighting track identified for use exceeding 30 amperes.
II. Each fitting attached to a heavy-duty lighting track shall have individual overcurrent protection.

The calculated load of a feeder or service supplying electrified truck parking spaces shall not be less
than __________ per space.

What is the minimum calculated feeder load for the lighting of 180 motel rooms that measure 22 ft. x
18 ft. each?

Lampholders installed over highly combustible material shall be ____________________.

In devices or utilization equipment with polarized connections, identification of terminals to which a
grounded conductor is to be connected shall be _____________ in color.

How many multiconductor cables are allowed in a ladder cable tray with an interior width of 8 in. if
all of the cables are smaller than 4/0 AWG, the line-to-line system voltage is 480 volts, and the diameter
of each cable is 0.4859 in.?

The residual voltage of a capacitor, rated 1,000 volts or less, shall be reduced to 50 volts, nominal, or
less within _______ after the capacitor is disconnected from the source of supply.

4 AWG copper conductors in vertical raceways shall be supported at intervals not to exceed
____________.

Shielded conductors operating at over 1,000 volts shall not be bent to a radius less than ________
the overall diameter of the cable during or after installation.

Each patient bed location in a Category 2 space of a health care facility shall be provided with a
minimum of __________ receptacles.

Overhead spans for open individual conductors used for outside feeders operating at 1,000 volts or
less shall not be smaller than _____________ copper for spans longer than 50 ft. unless supported by a
messenger wire.

For emergency systems, current supply shall be such that, in the event of failure of the normal supply to, or within, the building or group of buildings concerned, emergency lighting, emergency power, or both shall be available within the time required for the application but not to exceed _____________.

Wood braces used to support outlet boxes must have a cross section not less than _____________.

When calculating service loads, the first 20 kVA of lighting load for a hotel shall be calculated at _________.

Not less than __________ of free nonheating lead of electric space-heating cable shall be within a junction box used for connection to the cable.

Which of the following statements about solidly grounded neutral systems, rated over 1,000 volts is/are true?
I. Solidly grounded neutral systems shall be permitted to be either single point grounded or multigrounded neutral.
II. The minimum insulation level for neutral conductors of solidly grounded systems shall be 1,000 volts.